FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 178)

4 – Appendices NET SatisFAXtion 8.6 Manual 178
1089 Not a Class 1 modem: The modem does not support the Class 1
command set. Error type: NON_RETRYABLE .
1089 Send data was not supplied to the modem fast enough: Check
serial port settings to ensure the fax server can send data fast enough to the
modem. Error type:
RETRYABLE .
1095 Send collided with receive: An outbound port was allocated just as
the port began to receive a call. Error type: BUSY .
1106 Modem did not detect fax device on calling side: The modem
returned something other than CONNECT after answering the phone. This
usually indicates the caller was not a fax machine. Error type:
NON_RETRYABLE .
1107 Modem did not detect carrier on calling side: The carrier wait
timer expired after answering the phone for receive. This usually indicates the
caller was not a fax machine. The carrier_wait timer is 45 seconds by default.
Error type:
NON_RETRYABLE .
1108 Timed out waiting for a command: During phase B, the T1 timer
expired while waiting for commands from the sending fax machine. This timer is
35 seconds. Error type:
NON_RETRYABLE .
1109 Timed out waiting for a command: The 3 second T4 timer or the 6
second T2 timer has expired while waiting for a command from the sending fax
machine. Error type:
NON_RETRYABLE .
1110 CLASS1 buf fer full: The calling application has allowed more than 3
pages to be accumulated in the CLASS1 driver buffers. This would only occur if
the calling application was extremely slow and the pages were very small. Error
type:
NON_RETRYABLE .
1111 Invalid end-of-page signal: After receiving page data, the remote
unit should send 1 of 6 different end of page commands. It sent something
else. Error type:
NON_RETRYABLE .
1112 Busy: A busy tone was detected. Error type: BUSY .
1113 No dial tone: By default, the modem will listen for dial tone before
trying to place an outbound call. The most common cause of this error is not
having a working phone line plugged into this port. If the phone lines do not
provide dial tone, the modem must be configured to not detect dial tone before
dialing (see dial_progress_mode). Error type:
NO_DIAL_TONE .
1114 Modem did not detect fax device on answering side: The
modem returned something other than CONNECT, BUSY or NO DIALTONE while
dialing. This usually indicates the answering side was not a fax machine. Error
type:
NO_ANSWER .
1115 No Answer, remote device did not respond to handshake: The
call connected but the remote device failed to respond to repeated attempts to
handshake. The timer is 35 seconds. Error type:
RETRYABLE .
1116 Remote fax cannot receive: The remote fax device is configured to
not receive faxes. Error type: NON_RETRYABLE .
1117 Can’t agree on bit rate: The modem and the remote unit couldn’t fall
back to or agree upon any bit rate. This is most often caused by poor line
condition. Error type:
RETRYABLE .