FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 77)

2 – Server Administration NET SatisFAXtion 8.6 Manual 77
2.6.3.6 Scenario: Dial As-Is (No Validation)
2.6.3.7
Scenario: Adding Access Codes
Some services need long-distance access codes or other access codes
appended to the end of the fax number.
2.6.3.8 Adding Pauses to the Dial String
AudioCodes: p pauses, w waits for dial tone.
Class 1/Class 2: , (comma) pauses.
Brooktrout: p pauses, w waits for dial tone.
2.6.4
ANI (Caller ID)
When using Voice over IP, you must set your ANI. This will be used as your
“From” phone number. Note that only T1/PRI hardware will actually attempt to
use the specified ANI to make a call, and even then the T1/PRI service provider
may override the ANI you set, or may even reject calls with an “invalid” ANI (as
defined by that particular service provider).
To set global ANI, run the Change Server Settings utility, Start ► Programs ►
NET SatisFAXtion ►
Change Server Settings. Click on the Fax Hardware
Settings button, and change to the General tab. Click OK when you have set
your ANI.