FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 49)

2 – Server Administration NET SatisFAXtion 8.6 Manual 49
2.5.1.7.1.1 Emulating Line Routing
The standard configuration NET SatisFAXtion applies enables line routing
through the use of virtual phone numbers. The DID number NET SatisFAXtion
receives will indicate on which port the MediaPack or Mediant received the fax.
To use these line phone numbers, follow the instructions for DID routing above,
and use the port phone numbers given below.
The phone numbers on AudioCodes MediaPack MP114 and MP118s default to
the following:
Port 1: 1000
Port 2: 1001
Port 3: 1002
Port 4: 1003
Port 5: 1004
Port 6: 1005
Port 7: 1006
Port 8: 1007
The phone numbers typically configured on a Mediant 1000 are slightly
different. Note that Mediant 1000s often have customized configuration and so
the following does not necessarily reflect your Mediant’s configuration.
Module 1 Port 1: 1000
Module 1 Port 2: 1001
Module 1 Port 3: 1002
Module 1 Port 4: 1003
Module 2 Port 1: 2000
Module 2 Port 2: 2001
Module 2 Port 3: 2002
Module 2 Port 4: 2003
Module 3 Port 1: 3001
etc...
2.5.1.7.2 Brooktrout Fax Cards
Any Brooktrout analog (loopstart) fax card is capable of routing on Line or DTMF.
These cards must use DTMF Setup to enable DTMF digit capture on these cards.
Any Brooktrout DID fax card is capable of routing on DNIS. No additional
configuration is necessary.
Brooktrout T1/PRI cards are capable of routing on DNIS. No additional
configuration is necessary.
2.5.1.7.3 Eicon Diva Server
Eicon Diva Servers are capable of routing on DNIS from the T1 or PRI.
2.5.1.7.4 MainPine RockForce / IQ Express
Any MainPine analog fax card is capable of routing on Line or DTMF. These
cards must use DTMF Setup to enable DTMF digit capture on these cards.