KEYENCE CB-EP100 User Manual
Page 103
3-4 Message Communication
3-79
3
Communi
cat
in
g wit
h the
L
J
-V700
0 Ser
ies
- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
*1
Service data prescribes the following method for target OUT information.
UDINT: Status after function change
1: ON, 0: OFF
UDINT: Status after function indication
(OUT that becomes the specified target of the status after the function
change is set to 1)
All outputs are assigned to a bit, starting from the low bits
For example, assign timing on to OUT1 and OUT5 and timing off to OUT3 as
described below.
Status after timing change
00000011H(0000 - 0000 000
1 0001)
Timing specified target
00000015H(0000 - 0000 000
1 0101)
*2
Service data prescribes the following method for the target OUT. UDINT: Reset
target (1: ON, 0: Does nothing)
• Commands
• Responses (when successful)
0075H
(117)
Storage start
Indicates storage status during storage
processing. For details.
This function is enabled only in high-
performance mode.
None
0076H
(118)
Storage stop
Indicates storage status during storage
processing. For details.
This function is enabled only in high-
performance mode.
None
Item
Description
Data Example
Service Code
Designates the Specify "(Control input) (4DH)" (fixed
value).
4DH
Class ID
Designates CB Object (6BH) (fixed value).
6BH
Instance ID
Designates the ID number. The ID number (00H) of the
CB-EP100 cannot be designated.
01H
Attribute ID
Specify the attribute ID of the control input to be
specified from "Attribute."
"Attribute IDs supported by the instance service
4DH (control input)" of "(5) Control input to a
measuring instrument" (Page 3-78) and service data
006EH(110)
Service Data
None/target
OUT
information
Item
Description
Data Example
General status
A status (00H) is returned that indicates normal
completion of message communication.
00H
Service response data
There is no service response data.
-
Attribute ID
Name
Description
Service
data