KEYENCE CB-EP100 - Manual (Page 46)

- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
3-3 Cyclic communication
3-22
3
Communi
cat
in
g wit
h the
L
J
-V700
0 Ser
ies
Parameter List
Item Description
Error clear request
„ ON: When error status is ON, the error is cleared.
* If clearing the error does not address the cause of the error, error status will
again go on and the error code will appear again.
* If a number of errors have occurred, all errors that can be cleared are
cleared. If any remaining errors that have not been cleared, the error codes
of the errors are output.
„ OFF: error clear completion/error clear completion failure is turned OFF.
Timing request
OUTn (n: 1 - 16) „ ON: Changes states (ON or OFF) that specifies timing.
„ OFF: Timing completed/timing failure is turned OFF.
Auto-zero request
OUTn (n: 1 - 16) „ ON: Changes states (ON or OFF) that specifies auto-zero..
„ OFF: Auto-zero completion/auto-zero failure has been turned off.
Reset request
OUTn (n: 1 - 16) „ ON: Reset starts.
„ OFF: Reset completion/reset failure has been turned off.
Trigger request
„ ON: External trigger is issued.
„ OFF: External trigger completion/external trigger failure has been turned off.
Batch start request
„ ON: Batch start begins.
„ OFF: Batch start completion/batch start failure has been turned off.
Batch end request
„ ON: Batch end issued
„ OFF: Batch end completion/batch end failure has been turned off.
Storage start
request „ ON: Storage start begins.
„ OFF: Storage start completion/storage start failure has been turned off.
Storage stop
request „ ON: Storage stop begins.
„ OFF: Storage stop completion/storage stop failure has been turned off.
Memory clear
request „ ON: Clears internal memory.
„ OFF: Memory clear completion/memory clear failure has been turned.
Timing
ON/OFF specified
OUTn
(n: 1 - 16)
Specifies how timing status should be changed when a timing request is made.
„ ON: Timing is ON
„ OFF: Timing is OFF
Auto-zero
ON/OFF specified
OUTn
(n: 1 - 16) Specifies how auto-zero status should be changed when an auto-zero request
is made.
„ ON: Auto-zero is ON
„ OFF: Auto-zero is OFF
Program switch
request „ ON: Switches the current program to the program with the specified number.
„ OFF: Program switch completion/program switch failure has been turned off.
Program number
specification Specifies the number of the program that will be started when a program switch
is requested.