Configuration procedure for control/compact logix – KEYENCE CB-EP100 User Manual
Page 122
Advertising
5-6
5
Ap
pe
ndi
x
- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
5-4
Configuration Procedure for Control/Compact Logix Series
The following describes how to register the CB-EP100 (and the measuring instrument
connected to the CB-EP100) for EtherNet/IP communication in Control Logix.
The same procedure can also be used to configure Compact Logix.
1
Right-click a device capable of EtherNet/IP communication in
RSLogix5000 and then select New Module.
2
Click the "+" button of Communications, select "ETHERNET-MODULE
(Generic Ethernet Module)," and click the OK button.
3
Configure the ETHERNET-MODULE settings as shown below.
Advertising