KEYENCE CB-EP100 - Manual (Page 22)

- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
2-4 Configuring Communication with the CB-EP100
2-8
2
Con
nect
io
n a
nd
Conf
ig
urat
io
n
To display "Not Set" for the IP address, the network status indicator
(NS) must be off (IP address not assigned). To unassign the IP
address, hold down the Reset switch on the CB-EP100 for three
seconds or longer.
2
Select the device for which to set the IP address and click [Setup IP addr.(I)] to
display [Setup IP addr.].
Compare the MAC address to be displayed with the front panel MAC address
on the CB-EP100 and select the device for which to set the IP address.
Set an IP address which is not currently used in "IP addr.(required)(I)" and click
the [OK] button.
Using the [Search available IP addresses (F)] button enables you to
search for open IP addresses.
Point
Reference