KEYENCE CB-EP100 - Manual (Page 42)

- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
3-3 Cyclic communication
3-18
3
Communi
cat
in
g wit
h the
L
J
-V700
0 Ser
ies
OUT measurement
value
OUTn (n: 1 - 16)
Stores all OUT measurement values (32-bit DINT type Page 3-40).
Measurement values are output in the following units depending on
measurement mode.
„ Length (height, width, etc.): 0.01 m units
Example: 1234560
⇒12345.60
m
„ Cross-sectional area: 0.00001mm 2
units
Example: 123456
⇒ 1.23456mm 2
„ Angle: 0.001 units
Example: 12340
⇒ 12.340
* The OUT measurement value results in an alarm in the following cases.
• When measurement mode is "No measurement"
• When operation mode is "High-speed mode"
* When the OUT measurement value status is judgment standby, 80000001H
is returned.
* When the OUT measurement value status is alarm, 80000000H is returned.
* For details on how to obtain the current value, refer to page 3-24.
OUT measurement
value update count
OUTn (n: 1 - 16) Each time measurement values are output and updated, the count is
incremented by 1.
The count range is 0 to 65535 and 65535 is incremented to 0.
OUT measurement
value display unit
OUTn (n: 1 - 16)
Stores all OUT measurement value display units.
In the following cases, the display unit for OUT measurement values becomes 0
(initial value).
• When measurement mode is "No measurement"
• When operation mode is "high-speed mode"
Number of storage
data points
Stores the current number of storage data points (32-bit DINT type).
Item Description
Display unit code Minimum display unit setting
0 1mm
1 0.1mm
2 0.01mm
3 0.001mm
4 1μm
5 0.1μm
100 1mm 2
101 0.1mm 2
102 0.01mm 2
103 0.001mm 2
104 0.0001mm 2
105 0.00001mm 2
200 1deg
201 0.1deg
202 0.01deg