KEYENCE CB-EP100 - Manual (Page 136)

5-5 Objects for use with the CB-EP100
5-20
TCP/IP Interface Object
5
Ap
pe
ndi
x
- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
Reference 1) Status list
Reference 2) Configuration capability list
Reference 3) Configuration control list
Bit Name Description
0 to 3
Interface Configuration
Status
0: The IP address is not set (BOOTP).
1: The IP address is set. (Fixed)
2 or higher: Not returned with the CB-EP100.
4 Mcast Pending
This bit is set to 1 when "TTL Value" or "Mcast Config" is
set.
This bit is cleared to 0 when the power is turned on again
or the reset service is run.
5
Interface Configuration
Pending
This bit is set to 1 when an "Interface Configuration" is set.
This bit is cleared to 0 when the power is turned on again
or the reset service is processed.
6 to 31 Reserved All these bits are fixed at OFF.
Bit Name Description
0 BOOTP Client ON (fixed)
1 DNS Client OFF (fixed)
2 DHCP Client OFF (fixed)
3 DHCP-DNS Update OFF (fixed)
4 Configuration Settable ON (fixed)
5 Reserved OFF (fixed)
6
Interface Configuration
Change Requires Reset
ON (fixed)
7 to 31 Reserved OFF (fixed)
Bit Name Description
0 to 3 Startup Configuration
Sets and displays the IP address for next startup.
0: Fixed IP address
1:BOOTP
2 to 15: cannot be set. If set, the general status 09H (Bad
attribute data value) is returned.
4 DNS Enable OFF (fixed): The operation set by this bit is ignored.
5 to 31 Reserved All these bits are fixed at OFF.