KEYENCE CB-EP100 - Manual (Page 17)

2-3
2
Con
nect
io
n a
nd
Conf
ig
urat
io
n
- EtherNet/IP Network Unit CB-EP100 User’s Manual (LJ-V7000 Edition) -
2-2
Installation and Connection to measuring instrument
„ Connecting the CB-EP100 to measuring instrument
EtherNet/IP Network Unit CB-EP100 must be connected to measuring instrument
before it can function.
1
Insert the connector after removing the protective cover sticker from the
connector on the side of the measuring instrument.
2
Tighten the joint screws of the CB-EP100 using a screwdriver.
Tighten the screws to a torque of no more than 0.7N m.
Make sure that the measuring instrument are turned off before
connecting the EtherNet/IP Network Unit CB-EP100. Connecting
the CB-EP100 to a measuring instrument that is on could damage it
or the measuring instrument.
NOTICE
Fix using joint screws
Bottom