Comtech EF Data turboIP-G2 - Manual (Page 166)

turboIP-G2 Performance Enhancement Proxy Revision 2
Appendix A CD-TURBOIP-G2
A–2
A.2 Point-to-Point Configuration
Figure A-1. Point-to-Point Configuration
The configuration shown in Figure A-1 is a typical example where turboIP-G2s are used to
maximize the TCP throughput in a Point-to-Point system. Note the turboIP-G2s are placed so that
all TCP traffic between the Remote and the hub must pass through the turboIP-G2.
The following table defines the configuration settings for each turboIP-G2:
Configuration Parameter Hub turboIP-G2 Remote turboIP-G2
WAN Transmission Rate 45 Mbps (equal to the TX data rate
of Hub modem) 2048 kbps (equal to the TX data rate
of Remote modem)
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration No Selective Acceleration Rules are required. Rules could be added to
prioritize or set BW limits on any type of traffic.
Route Table No Route Table entries are required. Routes could be added to allow
remote access from outside of LAN subnet.