Comtech EF Data turboIP-G2 - Manual (Page 79)

turboIP-G2 Performance Enhancement Proxy Revision 2
Management via the CLI or Web Server GUI CD-TURBOIP-G2
5–5
Selection Entry Description Section
Gateway
Configuration
2, G • Set LAN and WAN Transmission Rates
• Set LAN Maximum Transfer Unit (MTU)
• Set WAN Maximum Transfer Unit (MTU)
• Set Congestion Control to Per-Connection or Rate Pacing, and
Error-Tolerance
5.2.3.2
Routing 3, R • Add, adjust, or delete IPv4 and IPv6 routes from system routing
table
(Route entries are only required for remote network access to the
turboIP-G2)
5.2.3.3
SNMP 4, S • Set SNMP subsystem On/Off
• Set SNMP system variables such as, System Information,
Community Strings, and Trap Destination.
5.2.3.4
Optimization 5, O • Turn Compression On/Off
• Turn Web Cache On/Off
• Turn DRE On/Off
• Turn CIFS On/Off
• Clear all Optimization Stats
5.2.3.5
Selective Acceleration 6, E • Add, move, edit, and delete TCP/UDP QoS/Acceleration rules
• Monitor statistics by priority
• Each rule has the following variables - Source IP address/Mask,
Destination IP address/Mask, Protocol, Source Port, Destination
Port, Priority, Bandwidth, Acceleration ON/OFF, and Status.
5.2.3.6
Administrative
Functions
7, d • Displays System Status for turboIP-G2 features – easyConnect,
FailToWre, Event Logging, Compression, SNMP, Web Interface,
SSH Interface
• Displays System Up Time, turboIP-G2 Version, Unit ID
• Used to administer the system functions – Restore Defaults,
Reboot, Shutdown, Upgrade, Reset System Time, Change
Password, Add User, Delete User
• Enable Logging, View or Clear Event Log
• Display/Reset System Statistics – Avg. Compression Ratio,
Session Statistics, WAN and LAN Statistics
• Save and Restore State
5.2.3.7
Command Line
Interface
8, L Allows user to run the following commands/queries: 5.2.3.8
get help ip log
menu ping route route6
rule set snmp
stats
system user tcpdump trace
Quit 9, Q Quit the CLI and return to the session login prompt 5.2.2.1