Comtech EF Data turboIP-G2 - Manual (Page 39)

turboIP-G2 Performance Enhancement Proxy Revision 2
Installation and Startup CD-TURBOIP-G2
2–3
2.2.1 Rack Mounting – Full-Width turboIP-G2 Configuration
The tool required for this installation is a medium Phillips
™ screwdriver. Each Full-Width
turboIP-G2 is provided with two Universal Front Rack Brackets (with pre-assembled handles
attached).
Figure 2-2. Full-Width Configuration – Universal Front Rack Bracket Installation
Final assembly of a Full-Width turboIP-G2 is accomplished as follows:
Step Single Unit Mounting Procedure
1 As shown in Figure 2-2: Secure one (1) Universal Front Rack Bracket (with pre-
assembled handle) to each side of the turboIP-G2 Full-Width chassis using three
(3) of the provided M3 x 6mm long flat head machine screws per side.
2 As shown in Figure 2-1: Install the turboIP-G2 Full-Width chassis assembly into
a 1RU rack space; use the front mounting ears to secure the configuration to the
rack’s front mounting rails as needed (mounting hardware provided by customer).
(2X) Universal Front Rack Bracket (3X) #6-32 x 1/4” lg. screws per side
(with pre-assembled handle)