Comtech EF Data turboIP-G2 - Manual (Page 53)

turboIP-G2 Performance Enhancement Proxy Revision 2
Configuration and Updating CD-TURBOIP-G2
4–5
4.5
turboIP-G2 Configuration Wizard
Use of the turboIP-G2 CLI is required for initial operational configuration. The user is required to
run the Configuration Wizard when the following criteria apply:
• Any time a new turboIP-G2 unit is shipped, and then installed, with Factory Defaults;
• Any time Restoring Factory Defaults has been selected from the CLI Administration
page.
The user-friendly Configuration Wizard provides a series of step-by-step instructions that guide
the user through this initial configuration.
4.5.1 Configuration Wizard – Operational Overview
At any time during the initial Configuration Wizard, the ESC key can be used to
cancel all changes and reboot.
Use the table that follows for an overview of the Configuration Wizard. Refer to the chapter
section identified in the “Section” column for detailed information about the pertinent
“Configuring Item.”