Comtech EF Data turboIP-G2 - Manual (Page 46)

turboIP-G2 Performance Enhancement Proxy Revision 2
Rear Panel Connectors CD-TURBOIP-G2
3–2
3.2 Console Connector (DB-9F)
The Console connector is a Type 'D' 9-pin female connector (DB-9F), providing the
user with configuration, monitoring and control of the turboIP-G2 via remote means
over an RS-485 multi-drop bus using the serial console Command Line Interface (CLI),
where data is transmitted in asynchronous serial form using ASCII characters.
The connector pinouts are as follows:
Pin # Signal Function Name
1 Rx Line Signal Detect Output
2 Tx Data Output
3 Rx Data Input
4 DTE Ready Input
5 Ground N/A
6 DCE Ready Output
7 Clear to Send Input
8 Request to Send Output
9 No Connection Output
For detailed information about using this interface for serial remote control of the turboIP-G2, see
Chapter 5. MANAGEMENT
VIA THE CLI OR WEB SERVER GUI
3.3 10/100/1000 BaseT Ethernet LAN / WAN Ports (2X RJ-45)
These are standard RJ-45 female receptacles, used as primary WAN and LAN traffic
ports. For units manufactured prior to November 2010, these ports were also used for
turboIP-G2 monitor and control (M&C) via Telnet, HTTP, and SNMP, as well as
updating turboIP-G2 firmware. This receptacle uses a UTP cable to connect to an
Ethernet hub, router, switch, PC, etc.
The connector pinouts are as follows:
Pin # Description Direction
1 TX+ Out
2 TX- Out
3 Rx+ In
4 N/A
5 N/A
6 Rx- In