Verilink C100 (880-502893-001) Product Manual - Manual (Page 116)

C100 and C150 SNMP MIB
D-2 Verilink C100 and C150 T1/FT1 CSU/DSUs 6/15/99
Transmission group
The C150 and C100 support the DS1/E1 MIB (RFC1406) in the
transmission group. References to dsx1 in RFC1406 apply to the T1
Network Interface. References to dsx1 in the Verilink proprietary MIB
apply to the T1 Customer Interface (typically a PBX).
The DS1 MIB consists of three groups: The Near End Group, the Far
End Group, and the DS1 Fractional Group. Verilink does not support
the Far End Group on either the C100 nor the C150 product.
Object ID prefix f
the MIB The object ID prefix for MIB is defined as follows:
1.3.6.1.2.10.x.y.z
where:
1 (iso)
3 (org)
6 (dod)
1 (internet)
2 (management)
10 (transmission)
x (specific ds1 group)
There are eight possible dsx1 groups:
• dsx1Config (x = 6)
• dsx1Current (x=7)
• dsx1Interval (x =8)
• dsx1Total (x=9)
• dsx1FarEndCurrent (x =10)
• dsx1FarEndInterval (x=11)
• dsx1FarEndTotal (x=12)
• dsx1FracFrac (x=13)
y (specific variable in group
z. (state of specific variable in group)
The “x.y.z” portions of the path are explained in further detail below.