Verilink C100 (880-502893-001) Product Manual - Manual (Page 129)

C100 and C150 SNMP MIB
6/15/99 Verilink C100 and C150 T1/FT1 CSU/DSUs D-15
The following notes apply:
1. For the purpose of this appendix, all information applies to both
the C150 and C100 products, unless otherwise noted.
2. The “w’ portion of the path will either be (1) or (2).
3. The “x.y.z” portions of the path are explained in further detail
below.
System
Configuration
Group
(sysConfig x=1)
The sysConfig Group consists of four read-write variables:
sysLoops (y = 1)
sysDensity (y = 2)
sysLinebuildout (y = 3)
sysTiming (y = 4)
sysLoops Object (sysConfigEntry 1)
This variable is used to enable/disable the unit from recognizing most
remote loop commands. When enabled, the unit will not respond to
V.54 loops to the DSX1 and the Channel. The following values ar
supported:
enable
disable
sysDensity Object (sysConfigEntry 2)
This variable determines whether the unit will enforce density to the
Network or be Clear Channel. The following values are supported:
Enforce
Clear
sysLinebuildout Object (sysConfigEntry 3)—C150 only
This variable determines the amount of line build out in decibels. The
following values are supported:
0dB
7.5dB
-15dB
-22.5dB