Verilink C100 (880-502893-001) Product Manual - Manual (Page 62)

Using the Console Port
5-8 Verilink C100 and C150 T1/FT1 CSU/DSU 6/15/99
Set Date Pressing the ENTER key when on Set Date selection moves the
blinking cursor to the low order day digit at the top left of the screen.
To change the day press ENTER until the desired day is displayed. The
BACKSPACE key also changes the day but it causes it to go backwards
instead of forward. To advance the blinking cursor to the right hand
letter of the month selection, press the SPACE bar. To change the
month, use the ENTER and BACKSPACE keys until the desired month
is displayed. To change the century and year, repeat previous steps.
Pressing the SPACE bar again moves the blinking cursor back to the
Set Date position.
Rename Header Pressing the ENTER key when on the Rename Header moves the
blinking cursor to the middle of the header field and erases the current
header. Any new header can be typed in at this point. The heade
characters allowable are the alphabet (both upper and lower case) and
the numbers 0 through 9. After the new header is typed in, press
ENTER to save the header and return to the blinking cursor to the left
of Rename Header selection. Pressing ESCAPE while typing in the
new header returns to the Main Menu leave the current header intact.
Once the ENTER is press while typing in a new header, the current
header is permanently erased and has to be retyped again.
Set Password Pressing ENTER while on the Set Password selection moves the cursor
to the beginning of the password field to the right of Set Password. A
new password can be entered at this point. The password characters
allowable are the alphabet (both upper and lower case) and the
numbers 0 through 9. After typing in the new password press the
ENTER key. The console requests Password Verification. Type in the
exact password again and the new password is saved. If the second
password does not match the first password, the message Invalid
Verification is printed on the screen and the blinking cursor is returned
to the left of Set Password. Pressing ESCAPE while typing in a new
password or verifying a password returns to the Main Menu and
leaves the old password intact. Pressing SPACE bar when on the Set
Password selection advances the cursor back to Set Time.
To return to the Main Menu, press ESCAPE.