Verilink C100 (880-502893-001) Product Manual - Manual (Page 58)

Using the Console Port
5-4 Verilink C100 and C150 T1/FT1 CSU/DSU 6/15/99
Console
menu/command
keys The console is user-friendly and very simple to operate since only a
few keys are needed. Except for the two control keys, all keys are
described on the bottom lines of the screens where they are used.
description of these keys follows:
SPACE BAR Pressing the space bar on all screens advances the
blinking cursor to the next field.
Letter B/b Pressing the letter B or b (case-insensitive) moves
the blinking cursor to the previous field.
ENTER Typing Enter causes 1 of 2 things to occur
depending on the screen displayed. On the Mai
Menu it selects the next screen to display. On the
other screens ENTER displays the next choice in
the field.
BACKSPACE Pressing the Backspace key on a field displays the
previous choice in the field.
ESC Pressing the Escape key on all screens displays
the Main Menu or exits Utility fields.
R/r Resest. Typing the letter R or r (case-insensitive)
on the Diagnostics & Statistics screen (
Figure 8-5,
Diagnostics and Statistics Screen ) resets the
following counters on the screen:
• NI Alarms: CRC-6, BVP, Blue Alarm
• All CI Alarms
• All Test counters.
The remaining counters are Telco controlled
registers and cannot be reset by the end-user.
Control D Holding the Control key down and then pressing
the letter D or d disconnects the modem.
Control R Holding the Control key down and then pressing
the letter R or r refreshes the screen.