Verilink C100 (880-502893-001) Product Manual - Manual (Page 2)

Copyright notices
VERILINK CORPORATION DISTRIBUTES
THIS REFERENCE “AS IS” WITHOUT
WARRANTY OF ANY KIND, EITHER
LIMITED OR IMPLIED. Verilink Corporation
reserves the right to revise this publication
from time to time without notice. Some states
or jurisdictions do not allow disclaimer of
express or implied warranties in certai
transactions; therefore, this statement may
not apply to you.
Copyright

1997 Verilink Corporation. All
rights reserved.
The following are trademarks or registered
trademarks of Verilink Corporation: Access
System 2000, Access Manager 2000,
Advanced Programmable Architecture,
Advanced Communications Series, and Craft
Interface.
Your right to copy software and this manual
is limited by copyright law. Making copies of
this reference, or any part thereof, without
prior written authorization from Verilink
Corporation is prohibited by law and
constitutes a punishable violation of the law.
Customer service and sales information
To receive more detailed information on
service options and pricing, contact
Customer Services at 1.800.VERILINK (1.800.
837-4546). Or access our FAX on Demand
System for our latest customer service
brochure at 1.800.957-LINK (1.800.957-5465).
FCC statement (for users of AS2000
equipment)
The Federal Communications Commission
(FCC) Rules require that you be notified of
the following:
This equipment has been tested and found to
comply within the limits for a Class A digital
device pursuant to Part 15 of the FCC rules.
These limits are designed to provide
protection against harmful interference in a
residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the use
is encouraged to try to correct the interference
by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the
equipment and receiver.
■
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
■
Consult the dealer or an experienced
radio/TV technician for help.
Per FCC Part 68 requirements, the customer is
required to notify the Telephone Company
prior to disconnecting any CSU from the
network interface.
The FCC registration number for Access
System 2000 is GICUSA-18804-DE-N.
The following references apply to this system:
a.The FCC registration number for Access
System 2000 is GICUSA-18804-DE-N.
b.The ‘USOC’ jack required [USOC RJ48C/
M/X]
c. The Facility Interface Code for Digital
Service is 04DU9-1KN/ISN/ISN/12N.
d.The Service Order Code for Digital Service
is 6.0N.