Verilink C100 (880-502893-001) Product Manual - Manual (Page 56)

Using the Console Port
5-2 Verilink C100 and C150 T1/FT1 CSU/DSU 6/15/99
the second unit is not used and can be stored in the shipping carton.
Connect additional units in a similar fashion, using the RJ11 cable
provided with them and storing the hoods.
Cabling a Modem to
the Console Port To cable a modem to the Console Port, an optional hood is required.
The hood can be supplied by Verilink or can be provided by the user.
The hood is a modular RJ11 to 25 pin male Part Number CH2R0001
and a wiring diagram can be found in
Appendix C, Interfaces and
Cables. The same cable provided with the unit is used with this hood to
connect the Console Port to the modem. If more than one unit is to be
controlled by the modem, use the RJ11 cable provided with the second
unit to daisy-chain it to the first unit. Plug one end of the second unit’s
cable into the modular connector on the rear of the first unit labeled
CONSOLE OUT. Insert the other end of the RJ11 into the modular
connector labeled CONSOLE IN on the rear of the second unit. The
hood provided with the second unit is not used and can be stored i
the shipping carton. Connect additional units in a similar fashion,
using the RJ11 cable provided with them.