Verilink C100 (880-502893-001) Product Manual - Manual (Page 28)

Configuration Using the DIP Switches
3-4 Verilink C100 and C150 T1/FT1 CSU/DSU 6/15/99
When position 6 is set to On and 7 off, only the console port ca
perform configuration. The only switches that can be programmed are
the unit address switches discussed in a previous subsection.
In either switch position, loops and test pattern diagnostics, on both
the console, and front panel operate.
Console or SNMP
SNMP must be set starting in the Console mode and the Console is
used to enter the IP address, after which the switches are reset to
SNMP mode. Switch 7 is set to On to activate SNMP. For full details
and procedures, see
Chapter 7, Configuring the Console Port for SNMP.
Remote loop
disable Switch pack 1 position 8 is used to enable/disable the unit from
recognizing most remote loop commands. With position 8 On, the unit
is disabled and does not respond to Remote Channel Loop. It will still
respond to the Network Interface Remote Loop commands (Loop
Up/Loop Down) and Payload Loop as required in Technical Reference
62411 and ANSI T1.403.
In the Off position, all remote loops are enabled and remote loops can
be set by remote commands.