Yaskawa iQpump Drive User Manual - Manual (Page 13)

1.2 Confirmations Upon Delivery
YASKAWA TM.iQp.01 iQpump Drive User Manual 13
1.2 Confirmations Upon Delivery
◆ Receiving Checks
Check the following items as soon as the iQpump drive is received.
Table 1.2 Receiving Checks
If there are any irregularities in the above items, contact the shipping company, the distributor or representative who sold the iQpump
drive, or a Yaskawa office immediately.
The iQpump drive is thoroughly tested at the factory. Any damages or shortages evident when the equipment is received must be reported
immediately to the commercial carrier that transported the material. Shipping damage is not covered by the Yaskawa warranty. After
unpacking and inspecting for damage, verify that internal wire connections have not come loose during shipment by spot checking wire
terminations with a screwdriver or the appropriate tool.
iQpump drive storage must be in a clean and dry location. Maintain the factory packaging and provide covering as needed to
protect the iQpump from construction site dirt, water, debris and traffic prior to and during construction.
◆ Nameplate Information
A nameplate is attached to the right side of each iQpump drive. The following nameplate is an example for a standard iQpump drive.
Figure 1.1 iQpump (P7U) Drive Nameplate
Item Method
Has the correct model of iQpump drive been delivered?
Check the model number on the nameplate on the right side of the iQpump drive.
Reconcile with packing slip and/or order information.
Is the iQpump drive damaged in any way?
Inspect the entire exterior of the iQpump drive to see if there are any dents, scratches or other damage
resulting from shipping.
Are any screws or other components loose? Use a screwdriver or other tool to check for tightness.
Note: The iQpump Drive Model Number and iQpump Drive Spec Number are required to completely identify an iQpump Drive.
YEA ITEM#: CIMR-P7U20111A-107
MODEL:
INPUT: AC3PH 200-240V 50/60Hz 53A
OUTPUT:
O/N:
S/N:
FILE: E131457 TYPE 1 ENCLOSURE IP20
1W06Z7123450001 PRG:0032
MASS: 7.0kg
AC3PH 0-240V 0-120Hz 46.2A 18kVA
SPEC: 20111A-U890107 CIMR-P7U2011 Drive Model Number Drive Spec Number
Weight
Input Power Rating
Output Power Rating
Serial Number
UL File Number
MODEL: Drive Model Number
INPUT: AC3PH 200-240V 50/60Hz 53A
OUTPUT:
O/N:
S/N:
FILE: E131457 TYPE 1 ENCLOSURE IP20
1W06Z7123450001 PRG:1021
MASS: 7.0kg
AC3PH 0-240V 0-120Hz 46.2A 18kVA
SPEC: 20111A CIMR-P7U2011 Drive Spec Number
Weight
Input Power Rating
Output Power Rating
Serial Number
UL File Number
■
Normal P7
■
P7 iQpump