Yaskawa iQpump Drive User Manual - Manual (Page 227)

E.5 PumpScada Software
YASKAWA TM.iQp.01 iQpump Drive User Manual 227
Manufacturer: Nudam
Model: ND-6530
Website: www.industrialpc.com
NUDAM ND-6530 Module Dipswitch Settings (located next to USB port)
Note: Refer to the user manual that comes with this module for windows driver installation. USB Cable is not included with
the converter.
E.5 PumpScada Software
Complementary Demo Version of the PumpScada software for the iQpump Controller is available on our website at
http://iQpump.yaskawa.com .
E.6 Energy Savings Estimation Software
Complementary Energy Savings Estimation is available on our website at http://iQpump.yaskawa.com .
Note: 1. DC link choke required on models which do not incorporate link as standard. Avoid using AC line reactors as voltage drop associated with line side inductors will reduce DC
link voltage level.
2. Manuals need to be changed by adding the following statement “When using E/F/P7U20P4 thru E/F/P7U2018 and E/F/P7U40P4 thru E/F/P7U4018 on a power supply
transformer with a capacity of 600KVA or more or when using single phase input, install a DC reactor. The reactor improves the input power factor and provides protection to
the rectifier circuit within the drive.”
3. Voltage tolerance of 240/480 Vac +10/-5% applies to single phase applications. Voltage below -5% will result in additional derating. Consult factory for additional derating.
4. Use HP column (blue) to select the drive based on applied motor HP. Amp column should not be used as the HP column is the limiting factor.
SW1 SW2
ON ON