Epson Stylus Scan 2500 - Manual (Page 20)

Safety Instructions 2-3
R4C427_V2
long.bk
Rev_C
A5 size SAFE.FM
2/1/00 Pass 2
R Proof Sign-off:
K. Nishi, K. Gazan _______
N. Nomoto
_______
J. Hoadley _______
❏ If you use an extension cord with the Stylus Scan, make sure
the total amperage of the devices plugged into the extension
cord does not exceed the cord’s ampere rating. Also, make
sure the total ampere rating of all devices plugged into the
wall outlet does not exceed the wall outlet’s ampere rating.
❏ Do not attempt to service the Stylus Scan yourself.
Unplug the Stylus Scan and refer servicing to qualified service
personnel under any of the following conditions:
❏ The power cord or plug is damaged; liquid has entered the
Stylus Scan; the Stylus Scan has been dropped or the cabinet
damaged; the Stylus Scan does not operate normally or
exhibits a distinct change in performance.
❏ If you are using the Stylus Scan in Germany, observe the
following:
To provide adequate short-circuit protection and over-
current protection for this Stylus Scan, the building
installation must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem
16 A- Überstromschalter abgesichert ist.
A Few Precautions
When using the Stylus Scan
❏ Do not put your hand inside the Stylus Scan or touch the ink
cartridges during operation.
❏ Do not move the print head by hand. Doing so may damage
the Stylus Scan.