PLANET MGSW-28240F - Manual (Page 245)

Command Guide of MGSW-28240F
one-zero Test pattern is set to 10101010.
rate The TST frame transmission bit rate - in Mega bits pr. second. Limit on Caracal is 400 Mbps. Limit on Serval is
1Gbps. This is the bit rate of a standard frame without any encapsulation. If 1 Mbps rate is selected in a EVC
MEP, the added tag will give a hi
<Rate : uint> Transmission rate value
size The TST frame size. This is entered as the wanted size (in bytes) of a un-tagged frame containing TST OAM PDU
- including CRC (four bytes). Example when 'Size' = 64 => Un-tagged frame size = DMAC(6) + SMAC(6) +
TYPE(2) + TST PDU LENGTH(46) + CRC(4) = 64
<Size : uint> Frame size value
Default:
Usage Guide:
To enable Test Signal of MEP.
Example:
To enable Test Signal of MEP 1 as below table
Switch# configure terminal
Switch (config)# mep 1 tst 3 dei mep-id 2 sequence one-zero rate 10 size 68
4.2.135 mep <Instance> up
Command:
mep <Instance> [mip] up domain { port | evc | vlan } [ vid <vid> ] flow <flow> level
<level> interface <port_type> <port>
mep Maintenance Entity Point
<Instance> The MEP instance number.
mip This MEP instance is a half-MIP
up This MEP is a Up-MEP
domain The domain of the MEP
evc This MEP is a EVC domain MEP.
port This MEP is a Port domain MEP.
vlan This MEP is a VLAN domain MEP.
flow The flow instance that the MEP is related to.
-245-