Efficient Networks Siemens Sinamics S120 - Manual (Page 162)

Vector control
4.20 Bypass
Drive Functions
162
Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4
U 
6\QFKURQLVPDFKLHYHG
S
E\SDVVFRPPDQG
U
6\QFKURQL]DWLRQUHTXHVWHG
IURPE\SDVVIXQFWLRQ
U
&ORVHFRQWDFWRU.
S 
&RQWDFWRU.FORVHG
0RWRU
RQFRQYHUWHU &KDQJHRYHU
SURFHGXUH
&RQYHUWHUPDLQV &KDQJHRYHU
SURFHGXUH
0DLQVFRQYHUWHU 0RWRU
RQPDLQV
U
&ORVHFRQWDFWRU.
S 
&RQWDFWRU.FORVHG
0RWRU
RQFRQYHUWHU
Figure 4-26 Signal diagram, bypass with synchronization with overlap
The motor is transferred to the line supply
(the drive converter controls contactors K1 and K2):
● The initial state is as follows: Contactor K1 is closed, contactor K2 is open and the motor
is fed from the drive converter.
● The control bit "bypass command" (p1266) is set (e.g. from the higher-level automation).
● The bypass function sets the control word bit "synchronizing" (r1261.2).
● Since the bit is set while the converter is running, the "Transfer motor to supply"
synchronization process is started.
● After the motor has been synchronized to the line frequency, line voltage and line phase,
the synchronizing algorithm reports this status (r3819.2).
● The bypass mechanism evaluates this signal and closes contactor K2 (r1261.1 = 1). The
signal is internally evaluated - BICO wiring is not required.
● After contactor K2 has signaled back the "closed" state (r1269[1] = 1), contactor K1 is
opened and the drive converter inhibits the pulses. The drive converter is in the "hot
standby" state.
● If the on command is withdrawn in this phase, the drive converter changes into the basic
standby state. If the appropriate contactors are being used, the drive converter is isolated
from the line supply and the DC link is discharged.
Retrieving the motor from supply mode functions the same but in reverse:
At the start of the process, contactor K2 is closed and contactor K1 is opened.
● The "Command bypass" control bit is canceled (e.g. by the higher-level automation).
● The bypass function sets the control word bit "synchronizing".