Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 114)

114
Navi
Parameter list (SH-101)
TONE Parameters
TONE TONE
SH-101 SH-101
* You may not be able to obtain the controller effect that you want with tones that use MFX Control.
Parameter Value Explanation
OSC OSC
OSC LFO MOD 0–100 Adjusts the depth at which the LFO modulates the OSC.
OSC RANGE 16’, 8’, 4’, 2’ Specifies the oscillator’s octave.
PULSE WIDTH
MOD
0–127
PW MODE =MANUAL Adjusts the pulse width value.
PW MODE =LFO/ENV Adjusts the depth of modulation.
PW MODE
Specifies the pulse width mode.
LFO
The pulse width is affected by the LFO.
MANUAL The pulse width is affected by PULSE WIDTH MOD.
ENV The pulse width is affected by ENV.
COMMON COMMON
Tempo 20.00–300.00 Sets the tempo of the tone (including the arpeggio, motion and sequencer).
BEND PITCH 0–1500 Specifies the range of pitch change produced by pitch bend.
BEND FILTER -63–0–+63 Specifies the range of filter change produced by pitch bend.
MODULATION
LFO
-63–0–+63 Specifies the amount of LFO applied by modulation.
PORTA MODE
Turns portamento on/off. If this is on, the pitch will change smoothly from one note to the next-played
note.
OFF
Regardless of the portamento time setting, portamento is not applied.
ON Portamento is always applied.
AUTO
Portamento is applied only when you play legato (pressing the next key before
completely releasing the previously-played key). This lets you use your playing
technique to control portamento on/off.
PORTA TIME 0–1023 Adjusts the time over which the portamento pitch change occurs.
PORTA CRV
Specifies the pitch change curve for portamento.
ORIGINAL
Change according to the original curve of the model.
LINEAR Change on a linear curve.
EXP1 Change in a non-linear curve (gentle slope).
EXP2 Change in a non-linear curve (steep slope).
KEY MODE
Specifies how notes are sounded.
POLY
Polyphonic
SOLO Monophonic
UNISON Unison
SL-UNISON Monophonic unison
AFT LFO -63–+63
Sets how much aftertouch changes the LFO intensity.
* This is only enabled for products with aftertouch.
AFT FREQ -63–+63
Sets how much aftertouch changes the low-pass filter intensity.
* This is only enabled for keyboards with aftertouch.
AFT LEVEL -63–+63
Sets how much aftertouch changes the tone volume.
* This is only enabled for keyboards with aftertouch.