Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 59)

59
Navi MFX List
02 SuperFilter
This is a filter with an extremely sharp slope. The cutoff frequency can be varied cyclically.
L in L in L out L out
R out R out R in R in
Super Super
Filter Filter
Super Super
Filter Filter
Parameter Value Explanation
Type LPF, BPF, HPF, NOTCH
Filter type.
Frequency range that will pass through each filter.
LPF: Frequencies below the cutoff
BPF: Frequencies in the region of the cutoff
HPF: Frequencies above the cutoff
NOTCH: Frequencies other than the region of the cutoff
Slope -12, -24, -36 [dB]
The slope of the filter (attenuation characteristics; amount of attenuation
per octave).
-12 dB: Gentle
-24 dB: Steep
-36 dB: Extremely steep
Cutoff 0–127
Cutoff frequency of the filter.
Increasing this value will raise the cutoff frequency.
Resonance 0–100
Filter resonance level.
Increasing this value will emphasize the region near the cutoff frequency.
Gain 0–+12 [dB] Amount of boost for the filter output
Mod Sw OFF, ON On/off switch for cyclic change
Mod Wave
TRI, SQR, SIN, SAW1, SAW2
How the cutoff frequency will be modulated.
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1: Sawtooth wave (upward)
SAW2: Sawtooth wave (downward)
SAW1 SAW2
Rate Sync OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate 0.05–10.00 [Hz] Frequency of modulation
Rate Note Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth 0–127 Depth of modulation
Attack 0–127
Speed at which the cutoff frequency will change This is effective if Mod
Wave is SQR, SAW1, or SAW2.
Level 0–127 Output Level