Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 67)

67
Navi MFX List
Parameter Value Explanation
Rate Note Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth 0–127 Depth of modulation
Phase 0–180 [deg] Spatial spread of the sound
Feedback -98–+98 [%]
Adjusts the proportion of the flanger sound that is fed back into the effect
(Negative values invert the phase).
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance D100:0W–D0:100W Volume balance between the direct sound (D) and the flanger sound (W)
Level 0–127 Output Level
15 SBF-325 (Flanger)
This effect reproduces Roland’s SBF-325 analog flanger.
It provides three types of flanging effect (which adds a metallic resonance to the original sound) and a chorus-type effect.
L in L in L out L out
R out R out R in R in
SBF-325 SBF-325
Parameter Value Explanation
Mode
Types of flanging effect
FL1
A typical mono flanger
FL2 A stereo flanger that preserves the stereo positioning of the original sound
FL3 A cross-mix flanger that produces a more intense effect
CHO A chorus effect
Rate Sync OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate 0.02–5.00 [Hz] Modulation frequency of the flanger effect
Rate Note Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Depth 0–127 Modulation depth of the flanger effect
Manual 0–127 Center frequency at which the flanger effect is applied
Feedback 0–127
The intensity of the flanging effect.
If Mode is CHO, this setting is ignored.
RMod Phase NORM, INV
The phase of the right channel modulation.
Normally, you will leave this at Normal (NORM).
If you specify Inverted (INV), the modulation (upward/downward
movement) of the right channel is inverted.
L Phase NORM, INV The phase of the flanging sound when mixed with the original sound.
NORM: normal phase
INV: inverse phase
R Phase NORM, INV
Level 0–127 Output Level