Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 55)

55
Navi
Parameter Value Explanation
Pedal Pole
STANDARD,
REVERSE
Specifies the polarity of the pedal connected to the PEDAL jack.
Keyboard
Velocity
REAL, FIXED
Specifies whether the velocity value changes according to the actual strength of your
playing (REAL) or is always a fixed velocity value regardless of how you play (FIXED).
Key Fixed
Velocity
1–127 Sets the velocity used when Keyboard Velocity is “FIXED”.
Bend Up Range 0–24 (semitone)
Sets how much the pitch changes (in semitones) when the pitch wheel is moved to
its highest point.
For example, when this is set to “24” and you push the pitch wheel all the way up
(away from you), the pitch goes up two octaves.
* The pitch may not reach the value that you set, depending on the sound parameter
settings.
Bend Down
Range
0–24 (semitone)
Sets how much the pitch changes (in semitones) when the pitch wheel is moved to
its lowest point.
For example, when this is set to “24” and you push the pitch wheel all the way down
(towards you), the pitch goes down two octaves.
Bend Mode
NORMAL The pitch bend effect works normally.
C+L
(CATCH + LAST)
The pitch bend effect applies only to the last-played note. If a note-on occurs while
pitch bend is already applied, the new note sounds at the center pitch. The pitch
starts changing only after the controller passes through the center position.
Mod Mode
This selects the parameter to which modulation is applied when you operate the MOD wheel.
PIT-LFO, FLT-LFO, AMP-LFO, CUTOFF, OSC1-POS, OSC1-PMOD-X, OSC1-PMOD-Y, OSC1-SMOD-DEPTH,
OSC1-SMOD-DRIVE
Mod LFO
Source
LFO1, LFO2 Selects the LFO controlled by the MOD wheel.
Mod LFO Rate
Sens
-63–0–+63
Adjusts how much the rate changes according to the modulation amount.
With greater values, the rate gets faster according to the amount of modulation.
Mod Sens -63–0–+63 Adjusts the depth at which the MOD wheel affects the LFO.
Mod OSC1
Pitch LFO Sw
OFF, ON Sets whether to apply Pitch LFO to OSC1 using the MOD wheel (ON) or not (OFF).
Mod OSC2
Pitch LFO Sw
OFF, ON Sets whether to apply Pitch LFO to OSC2 using the MOD wheel (ON) or not (OFF).
Mod OSC3
Pitch LFO Sw
OFF, ON Sets whether to apply Pitch LFO to OSC3 using the MOD wheel (ON) or not (OFF).
REV/DLY Knob
Mode
LEVEL, SEND
Switches the functions of the REVERB/DELAY [LEVEL] knob and the [SEND] knob
(+ SHIFT operation).
FX Order
This sets the routing for the MFX, CHO and REV/DLY.
MFX->CHO->REV
MFX->REV->CHO
CHO->MFX->REV
CHO->REV->MFX
REV->MFX->CHO
REV->CHO->MFX