Allied Telesis AT-S63 - Manual (Page 111)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Operations 111
Displaying the Port Trunks
To display the port trunks, perform the following procedure:
1. From the home page, select Monitoring.
2. From the Monitoring menu, select the Layer 1 option.
3. Select the Port Trunking tab.
The Port Trunking tab is shown in Figure 29.
Figure 29. Port Trunking Tab (Monitoring)
The Port Trunking tab displays a table with the following columns of
information:
ID
The ID number of the trunk.
Name
The name of the trunk.
Type
The load distribution method. The possible settings are:
SA - Source MAC address (Layer 2)
DA - Destination MAC address (Layer 2)
SA/DA - Source MAC address /destination MAC address (Layer 2)
SI - Source IP address (Layer 3)
DI - Destination IP address (Layer 3)