Resetting mstp to the default settings – Allied Telesis AT-S63 User Manual
Page 331
Advertising
AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Spanning Tree Protocols
331
Resetting MSTP to the Default Settings
To reset MSTP to the factory default settings, perform the following
procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 124 on page 312.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 125 on
page 315.
5. Click Defaults.
The MSTP settings are returned to their default values.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Advertising