Allied Telesis AT-S63 - Manual (Page 387)

AT-S63 Management Software Web Browser Interface User’s Guide
Section VI: Port Security 387
RADIUS Accounting
The AT-S63 management software supports RADIUS accounting for ports
operating in the Authenticator role. The accounting information sent by the
switch to a RADIUS server includes the date and time when clients log on
and log off, as well as the number of packets sent and received by a switch
port during a client session. For background information on this feature,
refer to Chapter 31, “802.1x Port-based Network Access Control” in the
AT-S63 Management Software Menus Interface User’s Guide. This
feature is disabled by default on the switch.
Configuring
RADIUS
Accounting
To configure RADIUS accounting, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Network Security option.
3. Select the 802.1x Port Access tab.
The 802.1x Port Access tab is shown in Figure 148 on page 372
4. In the Configure RADIUS Accounting section, configure the following
parameters as necessary.
Enable Accounting
Activates or deactivates RADIUS accounting on the switch. Select
Enabled to activate the feature or Disabled to deactivate it. The default
is Disabled.
Trigger Type
Specifies the action that causes the switch to send accounting
information to the RADIUS server. The possible settings are:
Start_Stop - The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
Stop - The switch sends accounting information only when a client logs
off.
Port Number
Specifies the UDP port for RADIUS accounting. The default is port
1813.
Type
Specifies the type of RADIUS accounting. The default is Network. You
cannot change this value.
Enable Update
Controls whether the switch is to send interim accounting updates to
the RADIUS server. A check in the box indicates that updating is
enabled. No check in the box means that updating is disabled.