Allied Telesis AT-S63 - Manual (Page 229)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 229
privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are encrypted
with the DES protocol.
None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between the
host and the switch are not encrypted.
10. In the Privacy Password field, enter a privacy password of up to 32
alphanumeric characters.
11. In the Confirm Privacy Password field, re-enter the privacy password.
12. In the Storage Type field, enter one of the following storage options for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the User Table. After making changes to an User Table entry with a
Volatile storage type, the Save Config option is not displayed on the
Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
User Table. After making changes to an User Table entry with a
NonVolatile storage type, the Save Config option is displayed on the
Configuration menu. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 User Table entry
takes effect immediately.
13. Click Apply to update the SNMPv3 User Table.
14. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting a User
Table Entry
To delete an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.