Allied Telesis AT-S63 - Manual (Page 32)

Chapter 1: Starting a Web Browser Management Session
32 Section I: Basic Operations
2. If you do create interfaces on a slave switch and designate a local
interface, the local interface must be applied to the common VLAN that
connects the slave switch to the enhanced stack.
3. To remotely manage a slave switch, start the session on the master
switch by specifying the IP address of the local interface on the master
switch and then transition to the slave switch using the enhanced
stacking feature in the AT-S63 management software.
Although the AT-9408LC/SP, AT-9424T/GB, and AT-9424T/SP switches
do not support Layer 3 routing, they do allow you to create one interface
and designate it as the local interface to support those management
functions that require an IP address, such as remote management.
The web browser interface of the AT-S63 management software does not
support routing interfaces. To configure routing interfaces you must use
the menus interface or the command line interface. For instructions, refer
to the AT-S63 Management Software Menus Interface User’s Guide and
the AT-S63 Management Software Command Line Interface User’s
Guide.
For background information on routing interfaces, static routes, and RIP,
refer to the AT-S63 Management Software Command Line Interface
User’s Guide. For background information on enhanced stacking and
virtual LANs, refer to the AT-S63 Management Software Menus Interface
User’s Guide.