Allied Telesis AT-S63 - Manual (Page 237)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 237
NonVolatile
Select this storage type if you want the ability to save an entry in the
View Table. After making changes to a View Table entry with a
NonVolatile storage type, the Save Config option is displayed on the
Configuration menu. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 View Table entry
takes effect immediately.
10. Click Apply to update the SNMPv3 View Table.
11. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting a View
Table Entry
To delete an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure View Table
and then click Configure.
The SNMPv3 View Table tab is shown in Figure 83 on page 235.
4. Click the button next to the View Table entry to be deleted and then
click Remove.
A warning message is displayed.
5. Click OK.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying a View
Table Entry
To modify an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.