Allied Telesis AT-S63 - Manual (Page 268)

Chapter 18: SNMPv3
268 Section III: SNMPv3
10. In the Storage Type parameter, select one of the following storage
types for this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the Target Parameters Table. After making changes to a Target
Parameters Table entry with a Volatile storage type, the Save Config
option is not displayed on the Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
Target Parameters Table. After making changes to a Target
Parameters Table entry with a NonVolatile storage type, the Save
Config option is displayed on the Configuration menu. Allied Telesyn
recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Target
Parameters Table entry takes effect immediately.
11. Click Apply to update the SNMPv3 Target Parameters Table.
12. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting a Target
Parameters Table
Entry
To delete an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 98 on
page 265.
4. Click the button next to the Target Parameters Table entry to be
deleted and then click Remove.
A warning message is displayed.
5. Click OK.