Allied Telesis AT-S63 - Manual (Page 49)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Operations 49
The System Time tab is shown in Figure 6.
Figure 6. System Time Tab
3. To set the system time manually, do the following:
a. In the System Time section of the tab, enter the time and date in
the following format.
hh:mm:ss dd-mm-yyyy
b. Click Apply.
4. To configure the switch to obtain its date and time from an SNTP or
NTP server on your network or the Internet, configure the following
options:
UTC Offset
Specifies the difference between the UTC and local time. The default is
0 hours. The range is -12 to +12 hours.
Note
If the interface on the local subnet from where the switch is reaching
the server is using DHCP to set its IP configuration, it automatically
attempts to determine this value. In this case, you do not need to
configure a value for the UTC Offset parameter.