Allied Telesis AT-S63 - Manual (Page 187)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 187
7. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying a Flow
Group
This procedure explains how to modify a flow group. If the flow group is
already part of a QoS policy assigned to one or more switch ports, you
must modify the policy by removing the port assignments before you can
modify the flow group. You can reassign the ports back to the policy after
modifying the flow group.
To modify a flow group, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Services option.
3. Select the Flow Group tab.
The Flow Group tab is shown in Figure 60 on page 184.
4. Click the dialog circle next to the flow group to be modified and click
Modify. You can modify only one flow group at a time.
The Modify Flow Group page is displayed, as shown in Figure 62.
Figure 62. Modify Flow Group Page
5. Modify the parameters as necessary. For definitions, refer to
“Configuring a Flow Group” on page 184.
6. Click Apply.