Allied Telesis AT-S63 - Manual (Page 92)

Chapter 5: Port Parameters
92 Section I: Basic Operations
Resetting a Port to the Default Settings
To reset a port to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected by
default, as shown in Figure 18 on page 80.
3. In the switch image, click a port to be returned to the default settings.
The selected port turns white. You can reset more than one port at a
time. (To deselect a port, click it again.)
4. Click Modify. To configure all of the ports, click Modify All.
The Port Configuration page is displayed, as shown Figure 19 on page
81.
5. Click Defaults.
The port(s) are returned to the default settings.