Allied Telesis AT-S63 - Manual (Page 243)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 243
protocol. Select this security level if you want to authenticate SNMP
users, but you do not want to encrypt messages using a privacy
protocol.You can select this value if you configured the Security Model
parameter with the SNMPv3 protocol.
Privacy
This option represents authentication and the privacy protocol. Select
this security level to allow authentication and encryption. This level
provides the greatest level of security. You can select this value if you
configured the Security Model parameter with the SNMPv3 protocol.
Note
The Context Match field is a read only field. The Context Match field
is always set to Exact.
11. In the Storage Type field, select one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the Access Table. After making changes to an Access Table entry with
a Volatile storage type, the Save Config option is not displayed on the
Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
Access Table. After making changes to an Access Table entry with a
NonVolatile storage type, the Save Config option is displayed on the
Configuration menu. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Access Table
entry will take effect immediately.
12. Click Apply.
13. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting an
Access Table
Entry
To delete an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.