Allied Telesis AT-S63 - Manual (Page 160)

Chapter 12: Classifiers
160 Section II: Advanced Operations
Modifying a Classifier
This procedure explains how to modify a classifier.
Note
If the classifier to be modified is currently assigned to an ACL or
QoS policy that has been assigned to a switch port, you must first
remove the port assignments from the ACL or policy before
modifying the classifier. After modifying the classifier, you can
reassign the ports again to the ACL or QoS policy.
To modify a classifier, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Network Security or
Services option. The Classifier tab is accessible from both menu
selections.
3. Select the Classifier tab.
The Classifier tab is shown in Figure 44 on page 154.
4. Click the dialog circle next to the classifier to be modified and click
Modify. You can modify only one classifier at a time. An example of
the Modify Classifier page is shown in Figure 47.
Figure 47. Modify Classifier Page
5. Modify the parameters as necessary. For descriptions of the
parameters, refer to “Configuring a Classifier” on page 154.