Allied Telesis AT-S63 - Manual (Page 24)

Preface
24
Version 1.2.0 Table 3 lists the new features in version 1.2.0 of the AT-S63 management
software. The only new feature supported in the web browser interface is
the Supplicant Mode parameter for 802.1x authenticator ports. The other
new features are supported in the menus and command line interfaces.
For background information on the new features, refer to the AT-S63
Management Software Menus Interface User’s Guide.
Table 3. New Features in AT-S63 Version 1.2.0
Feature Change Chapter and Procedure
MAC Address Table Added new parameters to the CLI
commands for deleting and
displaying specific types of MAC
addresses in the MAC address
table. The new parameters are:
ˆ STATIC, STATICUNICAST,
and, STATICMULTICAST for
displaying and deleting static
unicast and multicast MAC
addresses.
ˆ DYNAMIC,
DYNAMICUNICAST, and,
DYNAMICMULTICAST for
displaying and deleting
dynamic unicast and multicast
MAC addresses.
The web interface supports
displaying MAC addresses, as
explained in Chapter 6, “MAC
Address Table” on page 93, but
not the new parameters. The new
parameters are only supported in
the CLI interface.
Quality of Service Added the following new
parameters to QoS flow groups,
traffic classes, and policies:
ˆ ToS parameter for replacing
the Type of Service field of
IPv4 packets.
ˆ Move ToS to Priority
parameter for replacing the
value in the 802.1p priority
field with the value in the ToS
priority field on IPv4 packets.
ˆ Move Priority to ToS
parameter for replacing the
value in the ToS priority field
with the 802.1p priority field on
IPv4 packets.
The web browser interface
supports flow groups, traffic
classes and policies, as explained
in Chapter 15, “Quality of Service”
on page 183, but not the new
parameters. The new parameters
are supported in the menus and
command line interfaces.