Displaying target parameters table entries – Allied Telesis AT-S63 User Manual
Page 285
Advertising
AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3
285
The SNMPv3 Target Address Table tab is shown in Figure 110.
Figure 110. SNMPv3 Target Address Table Tab (Monitoring)
Displaying Target
Parameters Table
Entries
To display entries in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 9 on page 57.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 104 on page 279.
3. In the SNMPv3 section, click the button next to the View Target
Parameters Table and then click View at the bottom of the tab.
Advertising