Allied Telesis AT-S63 - Manual (Page 176)

Chapter 14: Class of Service
176 Section II: Advanced Operations
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS
priorities to egress priority queues. To change the mappings, perform the
following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Services option.
3. Select the Queuing & Scheduling tab.
The Queuing & Scheduling tab is shown in Figure 56.
Figure 56. Queuing & Scheduling Tab (Configuration)
Note
The Configure Egress Weights section in the tab is explained in the
next procedure, “Configuring Egress Scheduling” on page 178.