Allied Telesis AT-S63 - Manual (Page 169)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 169
Modifying an Access Control List
To modify an access control list, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Network Security option.
3. Select the ACL tab.
The ACL tab is shown in Figure 49 on page 166.
4. Select the ACL to be modified and click Modify.
The Modify ACLs page is displayed, as shown in Figure 51.
Figure 51. Modify ACLs Page
5. Configure the parameters as needed. For definitions of the
parameters, refer to “Configuring an Access Control List” on page 166.
6. Click Apply.
Changes to the ACL are immediately implemented on the switch.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.