Allied Telesis AT-S63 - Manual (Page 23)

AT-S63 Management Software Web Browser Interface User’s Guide
23
Note
When an AT-9400 Series switch with an IP address is upgraded
from AT-S63 version 1.3.0 or earlier to the latest version, a routing
interface is automatically created on the device to preserve its IP
configuration. The interface is assigned to the same VLAN that
functioned as the switch’s management VLAN. If the switch does not
have an IP address, no routing interface is created. For further
information on routing interfaces, refer to Chapter 32, “Internet
Protocol Version 4 Packet Routing” in the latest version of the
AT-S63 Management Software Command Line Interface User’s
Guide.
Version 1.3.0
Table 2 list the new features in version 1.3.0 of the AT-S63 management
software. For background information on the new features, refer to the
AT-S63 Management Software Menus Interface User’s Guide.
Table 2. New Features in AT-S63 Version 1.3.0
Feature Change Chapter and Procedure
802.1x port-based
network access control Added the following new features:
ˆ GUESTVLAN parameter for
supporting Guest VLANs.
ˆ VLANASSIGNMENT and
SECUREVLAN parameters for
supporting dynamic VLAN
assignments from a RADIUS
authentication server for
supplicant accounts.
ˆ MACBASED parameter for
supporting MAC address-
based authentication as an
alternative to 802.1x username
and password authentication.
Chapter 24, “802.1x Port-based
Network Access Control” on page
371
Modified procedure:
“Configuring Authenticator Port
Parameters” on page 375
Management Access
Control List Simplified the web interface for
managing the access control
entries in the Management ACL. Chapter 28, “Management Access
Control List” on page 417