Allied Telesis AT-S63 - Manual (Page 22)

Preface
22
History of New Features
The following subsections contain the history of the new features in the
AT-S63 management software.
Version 2.0.0
Table 1 lists the new feature in version 2.0.0 of the AT-S63 management
software.
Note
The AT-9408LC/SP, AT-9424T/GB, and AT-9424T/SP switches do
not support the IPv4 packet routing feature. However, these
switches do allow you to create one routing interface as a means of
assigning an IP address to the units to support those management
functions where an IP address is necessary.
Table 1. New Features in AT-S63 Version 2.0.0
Feature Change Chapter
Internet Protocol version
4 (IPv4) packet routing
with:
ˆ Routing interfaces
ˆ Static routes
ˆ Router Information
Protocol (RIP)
versions 1 and 2
New feature. This feature is not supported from
the web browser interface. For
background information and
commands, refer to the AT-S63
Management Software Command
Line User’s Guide.
Quality of Service Added the following parameters
to the Quality of Service (QoS)
web pages for flow groups, traffic
classes, and policies:
ˆ Type of Service (ToS)
ˆ Move ToS to Priority
ˆ Move Priority to ToS
ˆ Send to Mirror Port
These QoS parameters were
included in the menus and
command line interfaces in
earlier versions of the
management software.
Chapter 15, “Quality of Service” on
page 183
Modified procedures:
ˆ “Configuring a Flow Group” on
page 184
ˆ “Configuring a Traffic Class”
on page 190
ˆ “Configuring a Policy” on
page 198