Allied Telesis AT-S63 - Manual (Page 250)

Chapter 18: SNMPv3
250 Section III: SNMPv3
10. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting a
SecurityToGroup
Table Entry
To delete an entry SNMPv3 SecurityToGroup Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure
SecurityToGroup Table, and then click Configure at the bottom of
the tab.
The SNMPv3 SecurityToGroup Table tab is shown in Figure 89 on
page 248.
4. Click the button next to the SecurityToGroup Table entry to be deleted
and then click Remove.
A warning message is displayed.
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a
SecurityToGroup
Table Entry
To modify an entry SNMPv3 SecurityToGroup Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure
SecurityToGroup Table and then click Configure at the bottom of
the tab.
The SNMPv3 SecurityToGroup Table tab is shown in Figure 89 on
page 248.